View Single Post
  #3  
Old 11-25-2010, 09:07 AM
Newt Newt is offline
New Guy
 
Join Date: Jun 2009
Posts: 11
Default Re: Tadao Board in a pilot ACS?

Hey, just made this work last night!

Pull the brown and black wires from the microswitch out of the white 5 pin connector that harnesses to the on/off switch. They should come out with a little force with a little metal part crimped onto the end of the wire. Now place the microswitch wires onto the two outside pins in the microswitch port on the board (doesn't matter which direction).

You now have a working board! It will start up, blink red to indicate no eye operation, and then go solid red to indicate SAFE mode like normal. Press power briefly to switch to green FIRE mode.

Hope that helps!
Reply With Quote