View Single Post
  #10  
Old 02-12-2009, 12:14 PM
timewaste timewaste is offline
New Guy
 
Join Date: Jan 2009
Location: Windsor
Posts: 14
Default Re: Electra 08 sear prob

Quote:
Originally Posted by Master Tech View Post
To get the most out of your 9 Volt battery on a Electra take the coil set pin and grind it down to an overall length of 24mm or .945 inch remember not to grind it too short or you may not have enough pin length to push on the sear.

The increased gap between the sear and coil set pin allows the pin to accelerate with enough force to trip the sear properly even with a power supply that's below 8.5 volts.

I personally had a battery down to 8 volts and was still able to trip the sear before I had to replace the battery.
That is what Kingman told me ... they will just send you one if you let them know whats wrong
Reply With Quote