View Single Post
  #8  
Old 09-04-2008, 08:49 PM
BESERKER BESERKER is offline
New Guy
 
Join Date: Sep 2006
Location: MONTREAL
Posts: 12
Default Re: Electra 08 sear prob

Quote:
Originally Posted by Master Tech View Post
The increased gap between the sear and coil set pin allows the pin to accelerate with enough force to trip the sear properly even with a power supply that's below 8.5 volts.
it seems that on mine it requires more force to trip the sear-more than normal I would say.I push on the sear where the set pin would normally push & it's hard to trip it,i have to use a small screwdriver to push it.
It's very frustrating.
any suggestions?
Reply With Quote