Broken barbs!!! RAWR!!!!!!
 

I was taking apart my timmy the other day, and the barb that goes into the front block snapped off. Half of it is still in there.

Any suggestions to take this out?

Re: Broken barbs!!! RAWR!!!!!!
 

easy out.. or if your lucky, the curved tipped allen wrench sometimes works.. had it happen on my cocker waay back took it right out with one ;).

Re: Broken barbs!!! RAWR!!!!!!
 

or if you're really in a pinch...a small enough phillips screwdriver or torx bit

Re: Broken barbs!!! RAWR!!!!!!
 

yep.. Use a drill bit one size smaller then the size of the hole, Use a drill press to drill a hole through the barb (be sure not to hurt the threads) then just use a easy out. or if you are good like me you would have destroyed the barb without hurtting the threads.

Re: Broken barbs!!! RAWR!!!!!!
 

take a jewelers screwdriver that is the same size and just unscrew....

Re: Broken barbs!!! RAWR!!!!!!
 

:yeahthat:

I broke a barb off in my ram sleeve and used a jeweler's screw driver to get it out.