Spyder Forums

Spyder Forums (http://www.spyder.tv/forums/index.php)
-   Discontinued Markers (http://www.spyder.tv/forums/forumdisplay.php?f=94)
-   -   boucing (http://www.spyder.tv/forums/showthread.php?t=400)

therustyspoon6 01-02-2006 07:55 PM

boucing
 
i have done the 50g switch and magnetic mods to my spyder electric frame on a Extra, but now i have a problem with the trigger firing more than once when i pull it. could this be fixed with the T-chip or do i need to buy the entire T-Board?

Drefish99 01-02-2006 09:10 PM

Re: boucing
 
You have to buy a new switch. You prob. Messed it up when you modded it. I suggest getting the Tboard/ Tswitch combo or buy one of my pImpin 50g Switches. They are factory 50g's and not moded. :D

bigred76 01-02-2006 09:24 PM

Re: boucing
 
You could buy one of Dre's, slightly unmodify yours, or buy one from a local computer surplus store.

The T-Chip will not fix your problem. It is an upgrade to the T-Board, whih does have the answer to your problem. However, it is not necesary to go out and buy a complete T-Board for close to $50 when a $1-5 switch or mebbe even a free modification coud fix the problem. ;)

therustyspoon6 01-03-2006 11:30 AM

Re: boucing
 
the 50 switch i put in was not modified, i put it in just as it came from the factory

durrell 01-03-2006 11:43 AM

Re: boucing
 
Then it's a faulty 250g switch most likely, because the switches you buy from Radio Shack have to be modded.

therustyspoon6 01-03-2006 05:22 PM

Re: boucing
 
is there somewhere that shows how to do this mod?

big_daddy_d 01-03-2006 07:56 PM

Re: boucing
 
was on the old forums, someone may have a link to the thread about it on the nation

druid 01-03-2006 07:59 PM

Re: boucing
 
there was....:dodgy: but it was lost in the switch-over.

Remove the frame, trigger and board from the frame. Knock the 2 pins out that hold the switch and pull that out.
Look on the two ends of the casing...there are clips that hold the casing together. Use an Xacto blade to lift the tabs.
Now that the casing is apart, push in the button that closes the circuit (trigger contacts it) and look to see how the brass contacts touch each other. You need to bend them closer together to make the switch lighter or spread them apart to make the switch more resistant.
Reassemble the switch and reinstall.
Sorry I don't have a pictorial for you but that's basicly how you do it.

bomberpilot07 01-04-2006 10:35 AM

Re: boucing
 
ill try to do it in a couple of mins, but if my sister took my camera then ill have to use *gulp* the webcam ahhhhhh :dodgy:

druid 01-04-2006 10:37 AM

Re: boucing
 
Oh Nooooeeesssssss.....not The Web Cammmmmmm!!!!


All times are GMT -8. The time now is 03:20 AM.