Spyder Forums

Spyder Forums (http://www.spyder.tv/forums/index.php)
-   General Spyder Forum (http://www.spyder.tv/forums/forumdisplay.php?f=2)
-   -   leaking from barrel - aggressor model (http://www.spyder.tv/forums/showthread.php?t=22145)

wsconner 11-06-2012 11:35 AM

leaking from barrel - aggressor model
 
My son's 2010 Aggressor model has developed a small leak coming from the barrell--looks to be where the C02 enters the barrel at the vertical. We pulled it apart and lubed the o-rings, etc; which seemed to improve the leak a little, but not entirely. Any other suggestions or do all the internals need to be replaced? source?

Thanks

TheDarkShadow 11-06-2012 04:40 PM

Re: leaking from barrel - aggressor model
 
you might check the o-rings for nicks and or replace them. It sounds like it is definitely something in the mechanism of the cup seal/valve

shunut 11-07-2012 04:16 AM

Re: leaking from barrel - aggressor model
 
Like TheDarkShadow said, probably has to do the cup seal/valve. Check/replace the cup seal for damage as well as the orings.

vikingshadow 11-07-2012 04:14 PM

Re: leaking from barrel - aggressor model
 
I'll throw my two cents in also and say it's probably the cup seal/valve.

I was just feeling left out....

wsconner 11-14-2012 01:24 AM

Re: leaking from barrel - aggressor model
 
thanks for advise. replaced all the o-rings and caps with a replacement kit and everything works fine. Apparently these wear out pretty quickly... probably should keep them oiled more frequently.

TheDarkShadow 11-14-2012 02:19 PM

Re: leaking from barrel - aggressor model
 
I think it can sometimes be luck of the draw. i had a sonix from 05 that i never changed the o-rings. Granted I only ran about 6-8 cases through it in about 4 or 5 years.


All times are GMT -8. The time now is 05:24 AM.