Spyder Forums

Spyder Forums (http://www.spyder.tv/forums/index.php)
-   Electronic Markers (http://www.spyder.tv/forums/forumdisplay.php?f=92)
-   -   Flashing Trigger LED... vs3 (http://www.spyder.tv/forums/showthread.php?t=21994)

spyderon 11-23-2011 10:33 AM

Flashing Trigger LED... vs3
 
I just bought a mint but used vs3 and had to replace an o-ring in the ASA. Once that was done, I gassed it up for a test and it would shoot once and sputtered without re-cocking. I cleaned off the bolt and oiled the hammer only... everything looked good so i tried again and same thing..... sputter. After a few manual re-cocking and sputters and a tweak in the regulator it just started to work perfectly. After the hopper was empty from shooting a series of rapid fires, I looked at the LED on the trigger and it was blinking. The Manual doesn't say anything about blinking LEDs so I don't know what that means. Can anyone explain the blinking LEDs or the sputtering that was dealing with?

thanks

Ron

TheDarkShadow 11-24-2011 05:59 AM

Re: Flashing Trigger LED... vs3
 
idk about the LEDs but the sputtering is usually caused by a damaged striker o-ring


All times are GMT -8. The time now is 11:26 PM.