Spyder Forums

Spyder Forums (http://www.spyder.tv/forums/index.php)
-   General Spyder Forum (http://www.spyder.tv/forums/forumdisplay.php?f=2)
-   -   Special Edition Troubles (http://www.spyder.tv/forums/showthread.php?t=21912)

Pake 07-19-2011 03:37 PM

Special Edition Troubles
 
Hi,

I have 2 Spyder Special Editions. One works fine and the other doesn't. It would discharge air once and then would have to be re-cocked. I turned the valve around and now it'll discharge air with each trigger pull. The problem now is the balls merely roll out of the barrel.

I cannot see any indication of what could be the trouble and it is the same air canister I used on both guns. Sounds like it fires but nothing.

Any ideas? Should I interchange parts from the one to see what happens?

Thanks.

TheDarkShadow 07-19-2011 04:08 PM

Re: Special Edition Troubles
 
if the ball is rolling out of the breech/barrel then your detents are bad. im not sure where you could get replacement detents though since your gun is so old

Pake 07-20-2011 03:07 AM

Re: Special Edition Troubles
 
I don't think the ball just rolls out, just when trigger is pressed. seems like a pressure trouble, even though it sounds like it has enough.

TheDarkShadow 07-20-2011 05:10 AM

Re: Special Edition Troubles
 
ahhh i gotcha, have you checked your o-rings?

Pake 07-20-2011 07:32 AM

Re: Special Edition Troubles
 
I am gonna swap the firing mechanism with the working one tonight. If it works, I will replace O rings and see.

Pake 07-20-2011 02:26 PM

Re: Special Edition Troubles
 
I swapped striker bolt from my gun with his and still doing the same thing.

TheDarkShadow 07-20-2011 06:08 PM

Re: Special Edition Troubles
 
have you tried turning your velocity up?

Pake 07-21-2011 04:43 PM

Re: Special Edition Troubles
 
I took the spring out of the other one and cranked it all they way. Nothing. UGH!

TheDarkShadow 07-21-2011 06:14 PM

Re: Special Edition Troubles
 
Spyders are some of the simplest paintball markers. basically it sounds like a valve/velocity problem. the marker either isnt getting enough air the striker doesnt have enough force behind it so open the valve completely.

the internals should be identical in both markers. if you were to switch ALL internals it should work. if it didnt there is something wrong with the body/air line. are you sure youre putting it together correctly? check all the o-rings and make sure they are not worn or cracked. with this marker is it possible to put the bolt in upside down?

Pake 07-23-2011 12:40 PM

Re: Special Edition Troubles
 
Not possible to put the bolt in upside down. I am about to work on it later. Gonna go through it all again. It is a really simple gun, this is what boggles my mind.


All times are GMT -8. The time now is 05:07 AM.