Spyder Forums

Spyder Forums (http://www.spyder.tv/forums/index.php)
-   Veteran Forum (http://www.spyder.tv/forums/forumdisplay.php?f=3)
-   -   still a no go with the NDZ valve (http://www.spyder.tv/forums/showthread.php?t=3204)

ricochet08 05-09-2006 02:18 PM

still a no go with the NDZ valve
 
well, i got a 32* spring kit, in hopes that i could get my gun working correctly.

some combo's i've tried:

stock valve and stock valve pin = flawless operation.
stock valve and NDZ valve pin = flawless operation.
NDZ valve and NDZ valve pin = maching gunning or rapid firing, no velocity at all!!! the ball just rolls out of the barrel :(

some stuff i've tried:

polishing the sear = stopped the rapid firing only a little bit. i get maybe 5 good shots off until it starts again.

i thought having a stronger valve spring would help but still the same results occured.

any suggestions?
different spring combo?

additional info:
im using the weakest main spring in the kit. (think i should use a stronger one?) Only using the weakest spring to see how low i could get my psi. i have intentions to raise it :)

thx guys :D

claustrophobia9 05-09-2006 02:24 PM

Re: still a no go with the NDZ valve
 
you may be getting so much more air that the hammer isnt activating it well enough, lower pressure and increase spring.

thechubbss12 05-09-2006 02:29 PM

Re: still a no go with the NDZ valve
 
Well try a med valve and a Light main.... works perfect for my gun.....

Umm heavy valve, med spring is good for reballs.... at 220 FPS.

ricochet08 05-09-2006 04:04 PM

Re: still a no go with the NDZ valve
 
Quote:

Originally Posted by thechubbss12
Well try a med valve and a Light main.... works perfect for my gun.....

Umm heavy valve, med spring is good for reballs.... at 220 FPS.

thx chubbs :D
talked to u on yahoo and got it fixed :)
shoots fine with reballs. now i need to get to a chronograph.

the problem was the bad o-ring on the valve.

thx again :)

Spinal 05-09-2006 06:58 PM

Re: still a no go with the NDZ valve
 
i have the ndz valve, i use the stock valve spring and take the velocity knob adjuster completley out (using the stock main spring) and im at 255fps.

Nader 05-09-2006 07:47 PM

Re: still a no go with the NDZ valve
 
Lol, this is what I said in response to the first time you posted about having problems with the Valve.

Quote:

Originally Posted by Nader
could be the o-ring? or did you say you checked that?
I'm guessing either the spring isn't pushing hard enough on the cupseal, so try a harder spring or a higher pressure, if it turns out to not be the o-ring, that is.

:D:D:D:D:D:D:D:D:D:D

ricochet08 05-10-2006 06:35 AM

Re: still a no go with the NDZ valve
 
hmmm...sry Nader :)
didn't know if u were referring to the valve's o-ring or the VA :P

Nader 05-10-2006 11:02 AM

Re: still a no go with the NDZ valve
 
Lol, don't apologize, I'm glad you got it working though. :thumbup:


All times are GMT -8. The time now is 06:35 AM.