View Full Version : sundragon products

03-10-2007, 09:41 AM
i've heard alot of great stuff about sundragon's trigger and switch...i was just wonderin wats the advantage of gettin a new switch and wats the difference between their spli-switch and their "best"??
also does any1 kno when their going to have their triggers back in stock??

thanx for the help

edit: o and wats the advantage of their striker??

03-10-2007, 09:48 AM
Advantage of a new switch is you can shoot faster.
A lighter strike would cause less kick.

03-10-2007, 09:51 AM
will their striker be efeective for a lp steup?

03-10-2007, 09:53 AM
I'm not sure how light it is, but if its an aftermarket striker then it must be decently light. I'm assume it'd be fine, as I've never used one personally.

03-10-2007, 10:14 AM
ok....and about the switch, should i go wit the spli or "best"?

03-10-2007, 10:24 AM

03-10-2007, 10:31 AM
wats the difference...and isnt the spli easier to install?

03-10-2007, 10:32 AM
I have no idea.

03-10-2007, 10:34 AM
so ur just goin w/ the fact that it says best? lol

03-10-2007, 10:35 AM
Yup. :D

03-10-2007, 10:41 AM
go with the spli switch, it's what I have. The difference is the spli comes with the wires already attached so all you have to do is SPLIce it in to the existing switch wires. It makes for easier installation. As for the striker, it's nearly half the weight of the original stock unit. I also have that part and it works great; you just have to tune it with a spring kit. Why? Because a lighter hammer = less recoil, AND less weight/inertia so when it hits the valve pin, the valve is opened less than the stock hammer does. I went with a light valve spring and a medium (approximately stock oem tension) main spring. That gave me the dwell (time and amount the valve is open allowing gas thru) I needed for the pressure I run at, which is 300-325 psi. Good luck :)

03-10-2007, 10:45 AM
thanx a mill guys

edit: any1 kno about when the triggs come back?