PDA

View Full Version : I'm having a lot of problemes with my vs3


littlemat57
03-09-2007, 03:36 PM
My vs3 doesnt recock and the eyes dont work. I just fixed a leak in the gun and its very frustrating having all these problemes since ive only used it once

Reedoc
03-09-2007, 05:30 PM
About the bolt.....

Is your pressure up high enough?
Striker lubed?
Bolt clean?


About the eyes

Make sure they are clean...open up the covers and use ear cleaners to get anything off of them. Check for a pinch/rip in your eye wires. Check the board that they are completely plugged in.


More details would help me to help you :)

DRAGON
03-09-2007, 06:07 PM
Turn the pressure up to around 270psi until the reg is broken in. Remove the bolt(don't pull the pin out all the way!), use some lube like Dow33 and rub some on the side of the bolt where the 2 slots are for the detents. I'd say doing both will increase the chance of recocking. Are you using C02 or HPA? Is the on/off knob turned all the way on? Last but not least.....read the manual a few times. Do you know the difference between the modes, safe mode, semi and how to turn the eyes on and off? -