PDA

View Full Version : Aftermarket Reg. ??


Pwgsx
03-04-2007, 04:32 PM
After much reading and searching, it seems that my Stablizer/Reg. will not fit the stock VS2 front block. Is there any aftermarket blocks being made to accept it and if so, where??

Here's the deal:
I am either looking at the vs2 or a Pilot, but with the Pilot, I will have to go LP and add eyes ect. which I dont feel like messing with. The VS2 has everything already there, but my reg. of course. I also think after all the mods to the Pilot, i'd be paying much more!!

VS3 Sniper
03-04-2007, 06:53 PM
Trinty makes a front block for the vs2/3 its 39.99 on actionvillage.com.

Pwgsx
03-04-2007, 07:21 PM
cool thanks, they look the same as any other front block or am I missing something??

CareBear-Killer
03-04-2007, 09:52 PM
They are a little different. I'm not sure how, but they're not compatible.

There was another member here who bought the wrong front block from trinity, and it didn't fit. Not sure if the screw hole is in a different place, or if its a different size.

STRIKEFIRST
03-07-2007, 09:38 AM
Somone is now making a screw on thread adapter as well...check trinity's site and ebay.

Theheroguy
03-07-2007, 10:44 AM
no one reads my sticky huh
the trinity oneis asa threaded and therefore can have a reg screwed into it

slimloko
03-07-2007, 08:23 PM
TALKING ABOUT REGS
CP REGS ARE THEY GOOD FOR THE VS
I KNOW THE PRESSURE ON THE CP 0-500psi
I SAW IN EBAY A REBUILD KIT THAT CONVERTS from 0-500psi TO 0-250psi
IS THE 500psi ok for the vs3 or the low pressure better

DRAGON
03-07-2007, 08:35 PM
Why not just get a female Palmer's and call it a day? -

CareBear-Killer
03-07-2007, 10:15 PM
Psh, that's too easy dragon. There's no challenge in that. :D


As for the PSI from the reg, 500 is fine. just adjust it from 0-200 and see how it works, and adjust up from there. You'll never hit 500 with it on your marker, but atleast if, for whatever reason you need more than 250psi, its available.