PDA

View Full Version : Converting a Pure Engery HP tank to LP output


MVS1
02-22-2007, 01:56 PM
Hey guys I want to change my tank from HP to LP and I'm not sure if what I found is what I need. I found the PMI LP reactor but I'm not sure if this is what I need...http://www.skanline.com/pages-productinfo/category-2991_3011_3013/product-2442/paintball-tanks-nitro-tank-accessories-pure-energy-pure-energy-pmi-low-pressure-reactor.html?zenid=15d136f1d1d6c39fd7ed158a59a1565 0

Guidance from anybody in the know would be appreciated. Thanks.

Muddytaco
02-22-2007, 02:35 PM
According to pmi's site that is the low pressure drop in kit.


doing it for the a1?

MVS1
02-22-2007, 02:37 PM
According to pmi's site that is the low pressure drop in kit.


doing it for the a1?
Yeah i was gonna give that route a shot before getting a guerrilla air assault tank reg. Thanks.

DRAGON
02-22-2007, 03:01 PM
Seems it would make more sense to contact PMI and ask them wouldn't it? Also seems you'd want a different burst disk(s) since the output will be lowered. I wouldn't even mess with it at all unless I had all of the specific info. Could result dangerous if you didn't -

MVS1
02-22-2007, 03:09 PM
Good advice Drago, Their tech support is closed for tonight but I'll be giving them a call in the morning. From what I have gathered from online tech resources, Taco was spot on, it is designed as a drop in unit for the pure energy air systems, however I hadn't put any thought into the burst disc question. Thanks.