View Full Version : Question about the trigger frame

mayonase man
02-17-2007, 10:11 AM

So i was wonderin, How do I get those pin things out if I wanted to replace the trigger or install a switch. Ya know like that little thing the the trigger pivots on. So, how do I get them out?

02-17-2007, 11:00 AM
Here is Otters pics and instructions for removal and reinstallation of the trigger pin.
Good luck!

02-18-2007, 06:48 PM
Make sure where the pins are have a space to fall out, get a nail that will be large enough to hit it, get a big ole' hammer the bigger the better, make sure you hit it on the star side of the side that doesn't have the on and off switch, hit the pin out from that side. If it don't come out, hit it harder.

02-21-2007, 03:30 PM
Do not hit it on the star shaped side, that would be bad. Hit the other side when removing the pin. A nail set is the best tool for the job in my opinion, but you'll be fine if you just follow Otter's guide.