PDA

View Full Version : Is this Normal?


linkman_11
02-14-2007, 08:20 PM
I just recieved my Vs2 a few days ago and when I first took it out of the box i noticed that the spring was lying down, on the manual it is shown differently, the trigger still pops back after a pull, but when adjusting the trigger out further, it wont won't move back all the way,
here is the picture, vs2 owners please tell me if this is normal, Kingman Reps if this is not normal, how do i fix it? Is this covered by warranty?

Here is a pic

http://img266.imageshack.us/my.php?image=spyderpa4.jpg

Opteron-O3
02-15-2007, 06:56 AM
I don't think it's supposed to be like that...

samus129
02-15-2007, 11:11 AM
its not suppost to be like that. sadly i dont know how to fix it

linkman_11
02-15-2007, 12:41 PM
Well, i can do without for a while, but i really want to adjust my trigger out further, it won;t spring back farther that the factory default trigger setting, i might be able to fix it myself if an owner or a Kingman Rep can instruct me

Theheroguy
02-15-2007, 01:44 PM
prolly have to send it to kingman sorry dude

emf7301
02-15-2007, 01:50 PM
According to the VS2 manual, your spring is out of place. I don't own a VS2 but i assume they still use the same star pin to secure the triggers in place like on the pre-VS series trigger frames. If that's the case, it's a pretty easy fix if you have the right tools. You'll need a hammer and something to direct the force of the hammer onto the pin. Some use a small allen wrench (i could never get that to work); i use a nail punch. It has a nice small tip and a broader top. First, you should take the trigger frame off and i assume the grips too so you can find the pin holding the trigger in place. Look at each end and figure out which side is the star side (typically the left side when looking at the back of the trigger frame). You will want to hit the pin from the non-star side as the star part is what secures the pin in the frame and you don't want to hit that through to the other side. Then, it's just a matter of giving the non-star side some good hits until it's loose. Pull the pin and trigger out and put the spring back in place and put it all back together. Be sure to that when you put the pin back in that it goes back in from the same side in the same orientation, i.e. pin goes in left side with star part sticking out. Just tap the pin in until it sits flush and that's it. It's very simple and easy once you've done it before.

Just remember, this is assuming that kingman still uses the star pin to hold the trigger in place. If it doesn't have that or you are unsure, post a pic here first so we can tell. Otherwise, Good luck!

Edit: http://www.ottersccustoms.com/trigger.html - This page will show a picture of the star pin i am talking about.

DRAGON
02-15-2007, 01:51 PM
Remove the trigger and put it back the way it's supposed to be lol -

CareBear-Killer
02-15-2007, 07:14 PM
The trigger should be easily removed as there are new triggers you can buy for the marker.

Like pretty much everyone else has said, just pull the marker apart and put the trigger in the right way, as it is laid out in the manual.

linkman_11
02-16-2007, 06:48 AM
K, I'll do that.

MVS1
02-16-2007, 06:55 AM
While you've got it out, consider throwing in the magnetic trigger return mod. If you need the magnets just PM me your address, I've still got a ton of them.