PDA

View Full Version : bent valve


jr1992
01-22-2007, 07:42 PM
wat do i do. and how couldve it have happened.

Muddytaco
01-22-2007, 07:44 PM
are you talking about the pin that goes in the valve?

Nenkitsune
01-22-2007, 07:45 PM
you mean the valvepin is bent?

vwjimmy
01-22-2007, 07:45 PM
What exactly is bent? The valve pin? The seal area on the valve body?

calebh
01-22-2007, 07:49 PM
the valve obviously. duh. j/k

ooglieboogliebob
01-22-2007, 08:15 PM
I think it's talking about his co2 tank ?? ... it could have happened from you dropping it ?? Just leave it be.

If what im thinking about is not it what is it ??

wbpaintball
01-23-2007, 06:29 AM
Problem: Valve guide (star) is bent.
Solution: Replace the valve guide.

Possible Cause: O-rings on valve are bad.
Solution: This is the most time consuming problem a gun can incur, and is usually the last thing you’ll try to fix a leak. You have to disassemble the entire marker, even taking off the grip assembly to gain access to the gold screw which holds the valve in place. After taking all of the rear components and front components out, use a long straight object, such as a straight shot squeegee, to push the valve out. The valve does have a front and a back so notice how it comes out. The large opening with the surface that doesn't protrude out as much is the front or faces out like the barrel. The small opening that protrudes out more is the rear. Replace the O-rings, reassemble the marker and see if the leak is gone.

If even this doesn't fix your leak, there may be an imperfection on the valve where the cup seal comes in contact with, the large opening. Take the valve and rub it in a figure 8 on an emery cloth that is sitting on glass and this will help to smooth out any imperfections on the face of the valve.

wbpaintball