View Full Version : converson?
01-14-2007, 07:41 PM
Hi i need to know if these parts will fit on a mr1
-acs bolt from spyder pilot acs
-jj ceramic barrel
-dye sticky 3 grips
-lapco clamping feedneck without holes
-the camd 2 board from the pilot acs
If the board could fit how would i remove/put it on the gun?
these parts would not stay on each of the guns permantly i would put them on according to the where i play (in the woods-mr1, albany paintball-spyder pilot)
01-14-2007, 07:43 PM
id suggest just to buy one
but the barrel and the frame i believe will fit
01-14-2007, 07:47 PM
ok thanx. what about the grips,the feedneck, and the bolt? i would buy another frame but i will barely be able to afford the gun.:mad:
01-14-2007, 08:14 PM
I have an e-marker trigger frame from an imagine on my MR1, it bolts right up. As for the feedneck I recomend getting the CCM MR series feedneck adapter and with a CCM Ion Heli Clamp No Rise Feedneck. The bolt i'm not to sure about, why not give kingman a call tomorrow?
01-15-2007, 09:27 AM
ok so the feedneck wont fit or are you just reccomending another product? what about the grips? and also how would i remove the frame and put it on the mr1?
01-15-2007, 11:05 AM
the grips should fit. if you put the e-frame on it, to take off the old frame there should be 2 screws on the frame holding it on. take those off and take off the bottom line asa from the frame, and swap them out. the feedneck won't work, because the mr1 has a powerfeed. clamping feednecks and such are ment for vertical feed guns. you're pretty much stuck with using the elbow and hopper unless you go with a qloader (which is somewhat expensive) what he did recomend this though
it's an aluminum replacement for the feed it has, and converts it to a vertical feed. he also recommended using the ccm ion threaded heli clamp no rise feedneck
01-15-2007, 03:22 PM
ok thanks. so basicly every thing fits except the feedneck.
this saved me sooo much time:D
thank you everyone