My home mod parts

[valvepin]

Tell me if i did ok on the parts

1) striker
2) valve & pin

http://i125.photobucket.com/albums/p60/valvepin/valvepinmod.jpg
http://i125.photobucket.com/albums/p60/valvepin/striker.jpg

and my setup
I'm in the middle of a LP project the parts are some parts I did mods on


My set up

05 Imagine led
Ver C T Board, Shocktech Supperfly bolt
16'' sp All american & 14" progressive
Dye stickys & Membrane pad
Checkit Assault block & 0-600 psi Bob Long gauge
Cp long reg
CCM low rise, egg with z board
mod valve, valve pin,& striker
sundagon trigger

http://i125.photobucket.com/albums/p60/valvepin/ImagineLp.jpg

[Hossy]

you copied the links....they dont work

[valvepin]

try them now

[Hossy]

they work now, but no offense they arent the greatest pics ever,

But you did a good job

[valvepin]

Ok got better pics of the two mods

http://i125.photobucket.com/albums/p60/valvepin/striker2.jpg
http://i125.photobucket.com/albums/p60/valvepin/valvepin.jpg

[xtraking]

Looks nice and clean :thumbup:
My reccomendation, even though your pretty much done, is to try and aim for great efficiency, and not so much LP; however, Lp might come with a greater efficiency though.

[bigred76]

:yeahthat: I was getting good efficiency and LP merely by aiming to go efficient. Really, 100psi (I mean from the 200psi that people strive for in LP markers) doesn't make the marker that much louder, and is still under the LP category.

[kenangelamuna]

great job dude!