PDA

View Full Version : changing the trigger


blue_blank
11-17-2006, 12:22 PM
i went to that sundragon website and looked at their triggers for spyders and i need to no how to remove the trigger thats on the frame

OtterSC
11-17-2006, 12:32 PM
simple. remove the trigger frame from the body. look at both sides of the trigger. you want to focus on the pin itself. you should notice that one side has ridges while the other is smooth.

you would need to use a nail or even the allen wrench that is smaller than the pin and a hammer.

you want to tap on the pin that has ridges. may need to take a few good whacks to get it loose. do not hit the pin on the smooth side.

when you remove the pin, remember the side it came from. when you install the new trigger frame, the pin should be installed with the ridges going in through where the smooth side of the pin was and back into it's original place.

blue_blank
11-19-2006, 08:23 AM
ok i'll do that thx