PDA

View Full Version : IPI trigger - how change modes?


Jobberwocky
11-07-2006, 09:27 PM
Hey, I got an old imagine second hand and was curious about how to change the modes of fire? (I browsed the whole forum and couldn't find this) Thx

Foxfire
11-08-2006, 04:26 AM
The old imagine, well you press the button on the back of the trigger to change the modes(green=semi, orange=3 burst, and red=full auto). Once you have it on the mode you want you need to adjust the rate of fire(green=low 6bps or red=high 13bps), just hold down the button for a couple of seconds then the light will blink at that time you tap the button quick, it will switch the light to the next color. Then finally when you have the rate of fire blinking on the color you want, just hold the button down again and it will be set to your liking.

P.S. You can't change the rate of fire in semi

Jobberwocky
11-08-2006, 11:31 PM
thx, my modes won't change so I assume I'm missing that jumper...so without the jumper, it will only shoot semi?