PDA

View Full Version : Spyder Classic screw sizes


mullannix930
08-11-2006, 04:55 AM
I looked in the sticky and didn't find the screw sizes for a Spyder Classic. I had a water tight case fail and when my basement flooded the case got water in it. I am now looking for replacement screws for my classic (the only part that rusted. The ones that I need to replace are the grip frame mount, velocity adjuster, grip screws, and the old detent screws. They work but look bad. The marker works fine I just need to get those replaced. Any info would be great.

splaturout
08-11-2006, 05:17 AM
You might be able to find new screws at your local hardware store. Also you could look on ebay for parts. I found somestuff that I needed to replace there too.

http://cgi.ebay.com/Paintball-Spyder-Stainless-Bolt-Kit-Velocity-Adjuster_W0QQitemZ110017615808QQihZ001QQcategoryZ4 7236QQrdZ1QQcmdZViewItem

Would that work?

ooglieboogliebob
08-11-2006, 07:20 AM
The Frames Screws are (M5 X 12)
The Grip Screws are (M3 X 10)
The Detent Screw is (M4 X 6)

Im not sure about the Thumbscrew thread size, but if you havn't taken out the Venturi out of the bolt, i know it's the same thread size as that.