PDA

View Full Version : Going LP


paintmaster
01-06-2006, 07:57 AM
ok i ahve a quetion im going to go low pressure i knwo everything except the part about the springs im getting the 32* spring kit and it comes with hard springs and soft springs for the bolat and the valve. Sooo now my question do i put hard or soft springs for the valve and do i put hard or soft springs for the bolt to go low pressure. Anythign would be appreciated any help like that.

Thanks

bamf-hacker
01-06-2006, 08:10 AM
I suggest a spring kit. particularly a 32degree kit. these have 9 springs. though, only 6 are useable for your maker. 3 are for the main spring replacement. 3 are for the valve spring replacement. here is a run down as to what they will do.

Valve spring replacement:
strong spring = lower velocity
medium spring = stock spring velocity
weak spring = higher velocity

Main spring replacement:
strong spring = high velocity
medium spring = stock spring velocity
weak spring = lower velocity

*no problem mixing combos of springs in the marker to get desired effect.



There you go... Words from the master bible writer.

HacKeR

paintmaster
01-06-2006, 08:15 AM
oh my ****ing god this is excatly what i was looking for thanks man this helped out alot i knew i should have looked around first. anyway thatnks man.

bamf-hacker
01-06-2006, 08:17 AM
Don't thank me... Thank Otter!

HacKeR

ineasyi
08-02-2006, 03:01 PM
hey I have a spyder pilot acs and it only has one spring that I know of...is there a second spring? and where?

stylinbeaver
08-02-2006, 03:11 PM
One in the back and one where the VA goes on.

ineasyi
08-02-2006, 03:18 PM
hmmm I'm an idiot/amatuer...VA stands for?

ross * pilot
08-02-2006, 04:31 PM
vertical adapter, no prob. i had the same question a while back.. its the thing that your expansion chamber attaches to. if you take off your expansion chamber, you will have the VA screwed into the body... take off the VA screw and it will pop out b/c of spring tension. You then will find the VA spring

ineasyi
08-03-2006, 07:13 AM
hey thanks a lot!

ineasyi
08-03-2006, 03:27 PM
Another question about going LP...if I buy a VA adapter with a guage...all i need is an exspansion chamber without a gauge or a regulator with a gauge?

shubaadaadoomou
08-03-2006, 04:15 PM
whats a bolat? do these guns shoot bolats to?

druid
08-04-2006, 01:55 AM
Another question about going LP...if I buy a VA adapter with a guage...all i need is an exspansion chamber without a gauge or a regulator with a gauge?

If you get a VA w/ gauge, all you need is a regulator. A gauge on the reg is not needed because it's already on the VA. You need a reg...not an XChamber.

druid
08-04-2006, 01:56 AM
whats a bolat? do these guns shoot bolats to?

troll much?

ineasyi
08-04-2006, 07:32 PM
thanks a lot that's what i was confusted about.