macdev gladiator....

[DyNasty9]

ok i need to know to lower the pressure on a macdev gladiator do you screw the sets screw on the bottem in or out??

Nvm i figured it out

[leed]

LOL, don't screw it too far in though, you can damage the seat, and you'll have to replace it.

But yeah, it's like a CP reg, out = higher, in = lower.

[DyNasty9]

ya its flush with the bottem right now but i havent chrono'd.
when i took it apart theres suposed to be a ball bearing somewhere, i belive above the seat, but i couldnt find it, problem maybe?

edit ok im pretty sure the ball bearing is suposed to be under the seat, so im good i think. lol

[leed]

ya its flush with the bottem right now but i havent chrono'd.
when i took it apart theres suposed to be a ball bearing somewhere, i belive above the seat, but i couldnt find it, problem maybe?

edit ok im pretty sure the ball bearing is suposed to be under the seat, so im good i think. lol

Haha, yeah, it's under the seat. And I meant, don't screw it too far in when the bottomworks are attached to the top works. To get the seat out, you have to screw the set screw all the way up so you can get the seat out. Just remember to back it back out flush when you put it back together.