View Full Version : semi-auto locked

07-02-2006, 08:13 AM
i just got my pilot acs and whenever i go and try to switch it to burst or full auto i cant

i am following the directions in the manual to get it to auto

i also read that semi can be locked but it dosent say how to unlock it what do i do??

07-02-2006, 08:21 AM
black tourney lock jumper...it's missing or fell out

07-02-2006, 08:36 AM
:yeahthat: if u cant find it contact kingman or open up the grips and see if u can find it somewhere in there

07-02-2006, 10:37 AM
hrm ... if you pay for shipping i'll send you a few :) .... My dad has TONS ... he had 100's in his pocket for work at one point ...

Of course if you don't wanta buy them ... you could always wrap the two prongs in aluminum foil ... just make sure that doesn't get lose .. or uuh oh :(

07-02-2006, 10:48 AM
i also can not seem to get it off the safety

what am i doin wrong?

07-02-2006, 11:11 AM
you can't get it to turn on ??? ...... charge the battery for 12-16 hours

07-02-2006, 12:15 PM
:yeahthat: if u cant find it contact kingman or open up the grips and see if u can find it somewhere in there

wat does it look like and where does it go
and about how big??

07-02-2006, 12:21 PM
alright it is a small red square kinda looking box.if u open up the grips it might be rolling around somewhere in there.if u do find it in there however,there a two small pins next to the board.then put the jumper on those two pins and u will be able to cycle through modes again

07-02-2006, 12:32 PM
yea it was off and i put it on and i still can not cycle through buti ran out of co2 today is that a problem

kinda off topic but my bro pulled back the cocking pin how can i get it bak forward safely or does that not matter ?

07-02-2006, 12:56 PM
ok so what your off topic question was that the top cocking nob is stuck.alright if so heres what ya do.first,did u ever take off the grips and tightened it to tight?.if so loosen your grips and the cocking nob will not be stuck,it will be in firing position once u dry fire or somethin like that.if u tighten the grips on too tight it will cause the top cockin nob to be stuck in uncocked position or cocked position.but like i said follow those directions for the top cocking nob to come uncocked.but as for your changing modes problem even with the jumpper on the pins i cannot help u with that since that should have done the trick

07-02-2006, 01:02 PM
thanks for ur help

07-02-2006, 07:30 PM
my jumper block came off during a game today too. scared the crap out of my thought my board fried or somethin somehow. i took off the grip and it was layin there under the battery. any body else have this happen, and/or have any suggestions to make em stay tighter. i dont think ive put 1000 rounds through the marker yet and already stuff is startin to shake loose.

07-02-2006, 08:22 PM
thats right where mine was and i now got the gun to work fine but it scared me too

07-02-2006, 08:42 PM
give it a squeeze with a slip-joint plier...