PDA

View Full Version : how do i make the trigger more sensitive?


spyder_lover
05-04-2006, 03:54 PM
i just cant figure the dang thing OUT!!!!! i have an 03 version please help me if you can

big_daddy_d
05-04-2006, 04:00 PM
get a lighter switch for one and do the magnet mod.

ooglieboogliebob
05-04-2006, 08:37 PM
... yep .. 50g switch and use rare earth magnets for the mod ...

You could always bend the metal in the switch to customly mod it a bit also ..

big_daddy_d
05-04-2006, 08:50 PM
... yep .. 50g switch and use rare earth magnets for the mod ...

You could always bend the metal in the switch to customly mod it a bit also ..
When you buy the lighter switches thats pretty much all thats been done to them... Think Dex had a tutorial on the KUSA site don't think it made it over...

druid
05-05-2006, 05:04 AM
click me, read the appropriate title in the left column and do the mod (http://www.ottersccustoms.com/spyder.html)

.

ooglieboogliebob
05-06-2006, 12:41 PM
Well i found a faq to mod the swith ... and here it is :

#1 - Knock the pins that hold the switch, and the trigger, in place.

#2 - Take out the trigger, and then push the switch out into the the spot where the trigger was, keep all the wires connected.

http://98customballer.mypicgallery.com/stockswitchmod/1_large.jpg

#3 - Take a knife and pry open the lil tabs on both sides of the switch to open it.

#4 - Now, if you look at the left side of the switch ull see a lil arm holding the back end of the spring...

#5 - Bend that lil arm to the right. - Note: the more you bend the lighter the pull will be. I used a pen to bend it, dont bend it too far.

http://98customballer.mypicgallery.com/stockswitchmod/34_large.jpg

#6 - Put the top on the switch and install the trigger and switch w/ their pins.

#7 - Turn on ur gun and feel the awesome pull.

spyder_lover
05-07-2006, 05:46 PM
well i have a sweet spot trigger and the place where you stick the aller wrench is like deformed and wont fit in there

bigred76
05-07-2006, 06:35 PM
Deformed how? Do you have a picture to illustrate this?

ooglieboogliebob
05-07-2006, 07:16 PM
i know it's a dumb question but are you sure you have the right allen wrench size ... ?? ... pictars !!! like tim said :)

Hob Hayward
05-08-2006, 04:11 PM
Yeah, or make sure your using metric allen wrenchs, mine didin't come with the right one, but luckily my dad has tons of allen wrenchs.

slayer322
05-08-2006, 07:18 PM
did anyone think about adjusting the screw above the trigger to make it closer to the button?

big_daddy_d
05-08-2006, 07:27 PM
the more you unscrew it or back it out... (remember righty tighty lefty loosey) the closer it will sit to the trigger switch if not on it. Oh and welcome to the forums :D


nevermind I'm a retard...