View Full Version : Need help now.

12-31-2005, 09:51 AM
I got a new ShockTech trigger for Christmas and I'm putting it in and I don't know were the spring goes now. Can anyone help?

12-31-2005, 09:53 AM
Not having a pic to work with (and never having seen one in person), I'd wager a guess that it goes in the same spot as the stock one?

12-31-2005, 09:57 AM
I'll get a picture, one sec.

12-31-2005, 10:00 AM
You put the spring in that hole on the bottom part shown there

12-31-2005, 10:04 AM
Am I suppose to take out the screw type thing that was in there?

12-31-2005, 10:07 AM
no....the screw adjusts your pre-travel. You adjust that screw to shift the trigger closer or farther away from, the microswitch.The screw mounts from the top, while the spring goes underneath. The spring makes the trigger move forward, away from the microswitch.

12-31-2005, 10:07 AM
no leave that in there that is there so you can adjust how far the trigger is from the microswitch

12-31-2005, 10:09 AM
Alright. Thanks guys.

12-31-2005, 10:09 AM
You dont even have to have the spring, it's preference.

12-31-2005, 10:18 AM
Well, seeing as how I can't figure out how to get the spring to stay in the hole, I may have to go without a spring.

Durrell, is there any noticeable chang in how it works?

12-31-2005, 10:19 AM
the stock 250g switch is still pretty stiff even without the spring imo

12-31-2005, 10:22 AM
What do you mean? I don't really know what you mean by that. Are you saying it doesn't matter whether or not I use the spring?

12-31-2005, 10:24 AM
redlantern...get me on AIM...

10-20-2006, 04:46 AM
Use the spring... It will help you shoot much faster and get less bounces.

Also make sure you have extra springs in case one falls out while you are playing.

10-20-2006, 06:59 AM
The spring only helps to stop bounce. I took mine out and my trigger doesnt bounce but I think thats because the stock microswitch is 250g.

10-20-2006, 07:02 AM
just to let you all know, this thread is 10 months old.

i doubt hes having this problem now