View Full Version : 50g Problem

12-31-2005, 08:14 AM
I've got a problem with my 50g trigger switch. I put it in and it works great during dry fire. But when I gas the marker up one trigger pull and BRRRRRPPPP it jackhammers until you shut off the air. I've tried holding the trigger away from the switch and turning it off but it keeps shooting. Nothing seems to work. I just got a T-Board in and am going to try the debounce settings to see if that cures it, but I'm thinking it's mechanical not electronic. Any help would be great. Thanks!

12-31-2005, 08:48 AM
if all you did was drop in the T-board and switch and your marker was working fine before, it sounds to me like you need to play with/adjust your settings. my BLM acts similar, i just haven't messed around enough with the settings yet.

good luck!


12-31-2005, 10:27 AM
yes....what aod said. start with the settings listed on the instruction sheet and work from there

01-06-2006, 07:08 PM
My BLM does the same thing. It was as if the Switch was TOO sensative and the vibration of the marker firing had set it off.

I've yet to fix it, i broke my switch trying to mod it =(

But yea, Its the debounce. Otters site describes this malfunction.

Good Luck