PDA

View Full Version : Vertical adapter o-rings


divvichild
04-01-2006, 07:09 PM
ok, so i came home today after paintballing and i took my gun apart for cleaning. when i began to remove the vertical adapter, the o-rings burst and came flying through the screw hole. I just need to know if i can replace them with a tank o-ring since i have a ton of those.

NB_Hacker_NB
04-01-2006, 10:25 PM
They may be a little hard to put on, but once they are stretched a little, they'll be fine.:rolleyes:

SparkyGT
04-02-2006, 12:46 AM
sounds like ya still had pressure in the gun, did ya dryfire till it was out?

tex
04-02-2006, 08:44 AM
Tank o-rings will work on just about any seal except the hammer.

ooglieboogliebob
04-02-2006, 10:10 AM
actually ... they probably'll seal all of them ... but i'd probably not recommend it ... just get some o-rings at your local hardware store ... way cheaper

ad0131065
04-02-2006, 10:29 AM
actually ... they probably'll seal all of them ... but i'd probably not recommend it ... just get some o-rings at your local hardware store ... way cheaper
yea they're like 25 cent at home depot

divvichild
04-02-2006, 03:24 PM
yeh, i dry fired it till it was out. the o-rings worked fine, i thought they would since they're the same size as every other o-ring except the striker.

ooglieboogliebob
04-02-2006, 06:07 PM
eh ... then i guess you can use them ... i'd rather go to the hardware store and buy those o-rings though .. WAY cheaper ....