View Full Version : Replacing co2 tank valve

10-22-2011, 06:58 AM
I some how managed to bend the rod of my pin valve on my tank. I am looking to replace it but not sure if I should replace it with a normal valve, a valve with an on/off switch, or one with both an on/off switch and 3000psi gauge. Any advice?

10-22-2011, 03:19 PM
My advice would be to get a new CO2 tank. They aren't that much more than what you're proposing.

10-22-2011, 05:37 PM
I was going to say the same thing. Just not cost efficient, IMO, plus you get a whole new tank.