PDA

View Full Version : spyder mr2 issues


Jman21
07-12-2011, 07:42 AM
i have a mr2 and never use it. I pulled it out yesterday and it wont fire. electronic trigger works on all 3 modes. when a co2 is connected it just spits the ball out and you have to re-cock the lever, tried on 3 different tanks. I know the tanks are good, we tried them on a different gun. i took it apart and didnt see anything blocking. any ides or could i have missed something

Talon
07-12-2011, 10:06 AM
Sounds like an air problem. I would start with the striker o-ring, change that out and oil it. Then check and see if it works.

Jman21
07-12-2011, 11:16 AM
Were do I find the ring at, I dont know much about the gun

shunut
07-12-2011, 11:57 AM
Definitely an air problem, sounds like you aren't getting enough pressure. Is the tank new/recently filled? Have you ever taken the gun completely apart (I ask this because it could have been put back together incorrectly)?

Talon
07-12-2011, 02:40 PM
I would first try to find an O-ring at your local paintball field. If you can't get to a paintball field. Go here, this will is a complete o-ring rebuild kit.
http://www.orings-online.net/index.php?main_page=product_info&cPath=1_7&products_id=294

Jman21
07-12-2011, 07:33 PM
Definitely an air problem, sounds like you aren't getting enough pressure. Is the tank new/recently filled? Have you ever taken the gun completely apart (I ask this because it could have been put back together incorrectly)?

yea I got it refilled so it is completely full, when the tank is one another gun, the other gun fires with no problem

Jman21
07-12-2011, 07:36 PM
oh and no its never been taken apart, i took it apart today too see if there was a clog in the line other than that no. its aggravating cause i never use it. i will say i left the tank on for a little while, could that have caused something

shunut
07-12-2011, 07:48 PM
Leaving the tank shouldn't cause the problem you're having. Try lubing all moving parts, valve pin, striker and bolt. Also, once in a while some how, the bolt gets put in upside down, its happened to me, so make sure that the opening on the side of the bolt is facing down.

Atwaterpaintball.com
10-03-2011, 01:16 PM
You can go on youtube to look on how to take the paintball gun appart. it may not be the exact one. It could be o-rings that may be bad depending on your gun. it can have up to 5-8 o-rings. Check out How to Clean Your Paintball Gun, Spyder Marker - YouTube.