View Full Version : Spyder Flash

06-22-2011, 03:13 PM
Hey guys, just got a Spyder Flash and i dont know how to turn up the velocity...any help?

06-22-2011, 03:26 PM
Welcome to the forum!

There should be a "knob" on the back of the marker (lower tube) if you screw it in, it should increase the velocity. There may be a small set screw on the knob that you may have to back out to screw it in.

This might help:


06-22-2011, 03:49 PM
ya, i have that, but there is no screw screwed into it and it does not move either way.

06-22-2011, 03:53 PM
oh hold on, is the set screw the silver one that is in the gun, not on the actual thing you spin?

06-23-2011, 04:50 AM
The set screw should be on the knob itself, if it's still there. If the knob is turned in all the way and you're still not getting a high enough velocity to play safely then you could try replacing the main spring. Try a Maddmann spring kit (if Maddmann are still around).

06-23-2011, 12:26 PM
the spring is fine. I do not have a set screw and the knob does not turn either way to tighten or loosen.

06-23-2011, 12:30 PM
ahh nevermind...i just took it off the gun and tried to untighten it and i did...k so any other ideas besides the spring? all the O rings look good too...

06-23-2011, 05:24 PM
I would say that you're going to have to get a spring kit to get the velocity up on it. I used a Madmann kit when I used my spyders. Any spring kit will work though...