Tadao VS board into IPI eframe?

[noodles4u]

I was looking at the choices of boards out and I saw the Tadao VS board is pretty cheap. (can be had with an eye harness for 40 bucks). Even if isn't the most feature rich board, it'll do for adding some new fun to my Imagine Digital LED.

Anyways, I was wondering if anyone has swapped the Tadao VS board into an eframe. I know the 'noid and battery harnesses will match up, but I'm unsure about the trigger connection, which has 3 pins instead of two.

Anyone know if it's pretty much plug and play (with simple rewiring) or do i have to use a different microswitch?

[DFSniper]

i dont think so. the buttons and charging port dont line up with the frame, and im not sure about the microswitch harness.

[noodles4u]

I'm already aware that the bottons and ports don't line up. That can be fixed with a drill. I'm just unsure about the wiring for the trigger.

[big_daddy_d]

just get a t board...

[noodles4u]

just get a t board...

You know, I was thinking of that too. Then, I can mill the frame for the membrane pad, so it sits flush, or a little bit under.

Also, you didn't answer my question. Your post is almost useless to me.