View Full Version : Need some help for an MR1 project

06-28-2010, 04:51 PM
Does anybody know of a decent foregrip that I can use for an MR1 (using a 32* 1/8 NPT adapter) that I will be able to put a remote line into? I am going to be running my MR1 via remote, but I don't want to have to worry about going through an ASA and then macroline.

Here is a pic of my MR1 so you can see the work I've already gotten done: (sorry for the quality)


As you can see, I am currently running it off of 12g CO2. I could put the remote directly into the vertical adapter, but then there is nothing to use as a foregrip, and is somewhat uncomfortable on my hands.

06-28-2010, 07:43 PM
you could always pick up a gas thru off of an old spyder

06-29-2010, 11:41 AM
I actually just thought of something that might make this a whole lot easier. Can the part of the q/d on the ASA adapter of the remote simply screw off? If so, I can just take that off and put it directly onto an old expansion chamber, which I have a few of.

06-29-2010, 11:57 AM
yes. you can buy separate QDs too.

wont fit on regular 2 piece spyder expansion chambers though, theyre metric on their end.

Hob Hayward
07-01-2010, 08:45 AM

These things ROCK. Just a thought if you haven't don't already have a remote. Seriously, so much better than a normal remote or a slide check or anything like that.