PDA

View Full Version : Air Thur Stock


paintballer321
01-05-2010, 12:10 PM
is there a air thur stock for the Mr2 and has any one made there own air thur stock for the mr2

THUNDR
01-05-2010, 02:25 PM
I made my own. I think I've explained it before on this forum, I'll try to dig it up.

THUNDR
01-05-2010, 02:33 PM
Here's a pic of mine. It was a lot of trial and error but basically you just need to plug the hole where the airline originally goes into and drill into the side of the marker between the cup seal and plug that the shroud attaches to. Tap that for a 1/8 NPT macro line 90* fitting, tephlon tape it, and you should be good to go. I used a Special Ops Paintball SAW stock since they'yre made for air-thru.

http://i682.photobucket.com/albums/vv186/mako5590/Airthru004.jpg

paintballer321
01-05-2010, 02:51 PM
Thanks

paintballer321
01-06-2010, 11:45 AM
can u put the 1/8 fitint on the bottom of the gun or where the mag is

DFSniper
01-06-2010, 12:07 PM
yes. you just need a long enough hose.

paintballer321
01-06-2010, 01:42 PM
hey thunder wat parts did u use at the back of the stock to connect to the Remote line

THUNDR
01-07-2010, 03:57 PM
The Spec Ops stock has a hole in the bottom of the stock. I ran the macro line into a straight macroline fitting connected to a remote nipple with a double female 1/8 NPT connector. The nipple is from the outside of the stock, the connector with the macroline are on the inside. The hole in the stock is sandwiched between the nipple and double female.

THUNDR
01-07-2010, 03:58 PM
Also, I had to drill a hole for the macro line on the right side of the stock and inside where there's a bit of material blocking it. Not a big deal.