PDA

View Full Version : Mr1 Acs


paintballbob77
03-14-2006, 01:23 PM
Is the MR1 ACS compatible?? If so which one works with it?

Kingman-Rep
03-15-2006, 09:54 AM
the answer is yes. But if you decide to put a ACS bolt in the MR1, you will not have the quick strip feature that the MR1 has. On the MR1, the stock bolt can be removed without having to remove the hammer. If you put a ACS bolt in then you will have to remove the hammer and bolt as one unit.

I hope this clears up your question.

paintballbob77
03-15-2006, 02:34 PM
I wouldnt mind it. but can you recomend any upgraded bolts that work almost as good as the ACS that are still field strippable and if not which ACS # do i look for??

Kingman-Rep
03-15-2006, 03:33 PM
The only ACS bolt that will work is the rear cocking version. our part # is 30638.

paintballbob77
03-15-2006, 06:40 PM
Can I still use the shoulder stock with that??

Kingman-Rep
03-16-2006, 09:51 AM
no, it wouldn't have a place to fit.
I also have not seen any aftermarket bolts that are as short as the bolt used in the MR1, so if you used anything that was aftermarket it would not allow the stock to fit.

SupermanDan
03-22-2006, 03:03 PM
I've noticed on mine that because of the MR1's quick strip feature, the slot for the pin that connects the bolt and hammer doesn't go all the way to the back of the gun. but on other guns(like my friend's rodeo) it does. so, to fit the rear-cocking acs bolt in the MR1, would i have to make any mods to the gun or bolt? because i've tried to fit other rear-cocking bolts from other spyders, and because none of them are quick strip, they won't go in due to the pin for the hammer.