Critical
04-10-2009, 05:53 PM
I had a couple of these made up, one for a project of mine, the other two, I offer here for sale. I fit these for a VS1 front block, but any of the Spyder series that uses the -015 oring slip-fit connection should work fine.
You might ask, what's the point, I could just get a new front block. Well, yes, you could, however, if you're like me, I despise 15* assault blocks. I like my vertical mount to be, you know, vertical.
At the top, you can see how there are 2 set screws, at 90* instead of 180*, this is just as secure, but is a little cleaner visually if you mount the set screws towards the rear.
http://i5.photobucket.com/albums/y189/jeffstory/For%20Sale/CIMG0727.jpg
The bottom of the adapters are threaded for standard ASA regulators.
http://i5.photobucket.com/albums/y189/jeffstory/For%20Sale/CIMG0728.jpg
These are raw, un-anodized aluminum, so that you can get them done in whatever color makes you happy.
Price = $20 Shipped, ConUS
You might ask, what's the point, I could just get a new front block. Well, yes, you could, however, if you're like me, I despise 15* assault blocks. I like my vertical mount to be, you know, vertical.
At the top, you can see how there are 2 set screws, at 90* instead of 180*, this is just as secure, but is a little cleaner visually if you mount the set screws towards the rear.
http://i5.photobucket.com/albums/y189/jeffstory/For%20Sale/CIMG0727.jpg
The bottom of the adapters are threaded for standard ASA regulators.
http://i5.photobucket.com/albums/y189/jeffstory/For%20Sale/CIMG0728.jpg
These are raw, un-anodized aluminum, so that you can get them done in whatever color makes you happy.
Price = $20 Shipped, ConUS