PDA

View Full Version : ASA Prob


aznspyder
04-01-2009, 04:29 PM
Hey aznspyder again now with a new prob. My prob is related to my ASA, the prob is that when I screw in my tanks and my uncles tank they wont go in all the way and so I cant gas up my Vs2. When screwing the tanks in the tanks become harder to turn to the point where you cant turn anymore. I know sure that im not cross threading or stripping any of the threadson the ASA.
PS: I dont have money to buy a new one or old one from any where

Thanks in advance.

xsvly-fat
04-01-2009, 08:58 PM
Have you tried a different on/off? I don't think it would be a problem with the tank if two tanks have the same result.

aznspyder
04-02-2009, 01:53 PM
I havent had to time to try a new on/off yet. I may just get it check at a paintball shop when I go to rehydro my tank

ferret15
04-02-2009, 02:05 PM
vs2 has an on/off bottomline reg. soo you can't just magically replace it with a spare one:(

try rebuilding it, use some lube and if its a temp fix and does it again you may want new orings

http://www.youtube.com/watch?v=8zwxid_0TIs&feature=channel_page

aznspyder
04-02-2009, 04:15 PM
Hey guys I got bored and figure out to make my ASA work. All I had to do was wear down the threading a bit by turnin the tanks thread in and out of the ASA a while and now it works perfect.

martinez15
04-11-2009, 03:17 PM
are you using a compressed air or co2 tank