PDA

View Full Version : Ball Stopper Problem


desertfox384
03-30-2009, 06:36 PM
Ok so i was oiling seals and noticed my ball stopper was shredded at the tip, so i replaced with a new one and once i bolted everything down i noticed the bolt was getting caught on the tip of the new stopper. After a few hits by the bolt the tip shredded off again. Is this normal? If not what is causing this?

slim and shady
03-30-2009, 09:15 PM
do you have yout bolt in the right way? one side of the bolt should be channeled out for the detent so it doesnt shread it.