PDA

View Full Version : E-MR1 dropping pressure


buhhda05
03-29-2009, 05:26 AM
I just bought an EMR1 and the first time I took it out, I started playin on full auto and the bolt wouldn't always recock completely. What can I do? When I bought the gun I also purchased a volumizer with it but it wouldn't fit on the marker b/c it was threded and my marker wasn't. Any help resolving these issues would be greatly appreciated

irishwarrior
03-29-2009, 06:49 AM
Well, if you're using CO2 you could be experiencing shoot-down, causing the bolt to fail to recock. You could also be exceeding the cyclic rate of the MR1. And short of threading the marker, there isn't much you can do about the volumizer you have.

ProX
03-29-2009, 08:23 AM
Yes to the above, or a lesser possibility could be that it needs some oil.

slim and shady
03-29-2009, 06:23 PM
Well, if you're using CO2 you could be experiencing shoot-down, causing the bolt to fail to recock. You could also be exceeding the cyclic rate of the MR1. And short of threading the marker, there isn't much you can do about the volumizer you have.

:yeahthat:


:rolleyes: Irish thinks he knows everything :p

irishwarrior
03-29-2009, 06:28 PM
I don't think I know everything, I know I know everything ;)

slim and shady
03-29-2009, 06:30 PM
:lolsign:

buhhda05
04-04-2009, 11:44 AM
I appreciate all of the suggestions. I did find that Trinity paintballs seems to make a volumizer that might fit on my gun.