PDA

View Full Version : clamping feedneck????


jdlphilly
02-07-2009, 08:24 AM
which feedneck is compatible with the MR2 WITH EYES. i am confused which ones work with eyes and which ones don't.

slim and shady
02-07-2009, 09:11 AM
trinity makes the onlt one for the MR2 w/eye its simple ask for the one with the eye cover and your set.

jdlphilly
02-07-2009, 05:09 PM
I was looking online and some of the trinity t-lock ones for the mr series say that it will not cover eye wires like the stock feedneck does. is that OK?

slim and shady
02-07-2009, 05:19 PM
no that is clearly the one you dont want so get the one that says it covers the eyes and wires. If you use the other one it will wreck the eyes

jdlphilly
02-09-2009, 02:52 PM
thanks.

they should be about 30 bucks right.

slim and shady
02-09-2009, 09:18 PM
usd of corse

jdlphilly
02-21-2009, 07:32 PM
the feedneck came in the mail today and i installed it. i went to put my hopper (gravity) on and it is really hart to force into the feedneck. i even tried to put it in when the clamp and screw were out ot the part. if this is normal this is fine i just want to know, and will this happen with all hoppers?

slim and shady
02-21-2009, 10:08 PM
its not a big deal some hoppers have thicker feednecks just sand them down slightly, be careful not to take to much though you would be ammazed how much material a few seconds of sanding takes off. the feedneck you bought is normal and fine. Just sand the feedneck slightly on the HOPPER you wish to use.

Spends
03-30-2009, 07:15 PM
How does the clamping neck fit on the gun, Does it have screw holes. Or how do you get it on

slim and shady
03-30-2009, 09:19 PM
the same way the stock feedneck attaches to the marker.