PDA

View Full Version : no velocity out of mr1. help


speedemon
09-16-2008, 10:42 AM
I have a mr1 with a rocking trigger, alamo city low blow bolt, and 16" J&J barrel. I can't get any velocity out of it. I have put in a heavier spring and all the orings are good. The balls just don't get out there anymore. I can only get it ti chrono at about 245. I'm running co2 without a remote. Please help.

ferret15
09-16-2008, 12:44 PM
did you compare the low-blow to the stock one?

slim and shady
09-16-2008, 05:27 PM
check to ensure that your airhose ect is not pluged, lub the marker well and out of curiosity what spring do you have in there out of a kit? if so what kit and what color of spring? this is an od problem seeing as how most MR1 shot way hot.

sneekypete
09-17-2008, 05:19 PM
I would hook the Co2 staight to the gun and chrono. Maybe your remote line is cloged

speedemon
09-17-2008, 06:46 PM
I am not running a remote line. The gun gets cleaned and oiled every time I play. I had the red spring in which is supposed to be the heavy spring.

sneekypete
09-17-2008, 06:51 PM
The only thing I can think off and I think its a long shot. What is your bore size too paint ratio. Maybe your paintballs are too small?

slim and shady
09-17-2008, 08:28 PM
could be your valve isnt letting enough air through

bigred76
09-17-2008, 10:40 PM
Wow, so many sugestions from so many directions.... I don't know if you can do this in an MR due to it's design, but the best spring combination I've found for most guns is a medium valve and light main with regulator tweaking to get in the right velocity range. If you do not have a regulator (don't see it in your specs) swap your springs out for a medium main, medium valve, and see where that gets you. Then a light valve, medium main.