PDA

View Full Version : whats wrong with this marker


Hitman08
07-22-2008, 07:35 PM
i have a old Spyder Compact with the single trigger bought years ago New now when i put Co2 in it (full tank) and pull the trigger it burps like the tank is empty
i replaced the Striker O-ring & cup seal same problem i was told possibly the striker plate whats your thought on this:cool:

Ace24
07-22-2008, 08:04 PM
Sometimes where the striker and the plate come together wears down and it doesn't grab anymore. It's possible you'll have to replace your striker.

druid
07-22-2008, 08:29 PM
Old Spyders and clones sometimes have wire mesh plug jammed into the hole in the VA. If yours has this, the mesh bundle is likely clogged with CO2 dirt.

Take a 1mm drill bit and drill a hole into the center of the wire mesh and then use an easy-out to remove it completely from the VA.

If you feel compelled to replace it, just use any wire screen filter used for Ions or any other Spyder marker.

Drefish99
07-22-2008, 08:34 PM
Make sure the valve spring isn't binding or too large where it is preventing the valve from opening all the way. Also make sure the cup seal is tight on the pin.

Hitman08
10-01-2008, 06:52 AM
thanks guys i figured it out the trigger sear was bad