View Full Version : Bolt?

02-28-2006, 03:08 PM
Hi People..,

A fast question about the Bolt, my gun is the Electra 05 ACS, i am planing to buy the New Designz Equalizer made of delrin,..., btw what do you think about that bolt.., going to the question.., it is the top cocking version the one for me??? (i suppose its the one, cause the pin)

Thanks for the help.


02-28-2006, 03:46 PM
I would sugest you keep the bolt you have, unless there's some serious problem you are having with it.

Yes, your marker is top cocking, so you'd get the top cocking bolt.

02-28-2006, 04:29 PM
yep, i'd keep it if i were you too .. that stock bolt is pretty good .. it's derlin and it's acs.

03-01-2006, 02:32 PM
ohh, well.., i know its good, but since i was trying to reach some LP, i thought that could be ok, i will folow your recomendations then, and try with the regulator stuff, thanks

03-01-2006, 04:39 PM
Delrin is the lightest type of bolt you can get, and ACS is the best bolt for Spyders except for the JAM Enterprises bolt. :) Go for a Torpedo or CP regulator instead.

03-01-2006, 06:21 PM
heh i'd go with the Torp for 1st pick IMO though ... you could probably pick up a torp from pbnation or on kusa's bst thread for 30 dollars +- ... depending on condition and seller. I'd probably also go for a new VA (assault block / trinity)

03-01-2006, 07:38 PM
yes, but, i don`t have N2 yet, i suppose those regulators doesn`t support co2 right? what will be the choice then? palmer? (i think they are expensive isnīt?)

03-02-2006, 02:54 AM
nope, the torp supports co2 just fine :)