PDA

View Full Version : Musashi 7 for RSX Tadao Board....??


Cmudge26
07-06-2008, 10:53 PM
i recently about the Musashi 7 chip for my Tadao Board.... one problem i have no clue on what settings is great for the RSX... i mean i tried setting it myself but i end up messing up the shooting (blah blah)....

Help please explain or if anyone has settings let me know :confused: :confused:

Cmudge26
07-07-2008, 11:56 AM
im guessing no one knows... haha

irishwarrior
07-07-2008, 01:11 PM
Try posting in the electronic frames forum.

Hazmat13
07-07-2008, 06:15 PM
how did you mess up the shooting and what do you mean by best? Defaults usually work the best for me...

Cmudge26
07-07-2008, 08:59 PM
how did you mess up the shooting and what do you mean by best? Defaults usually work the best for me...

i try to set up my own settings but my RSX started shooting 2 balls at once... so i was trying to figure out how to reset the board to default. it says to push the "Lock Button" where is that at? :confused:

Master Tech
07-08-2008, 09:06 AM
Keep the coil set time to no less than 5.00 ms. and remember each blink of the LED is 0.50 ms so it will have to blink 10 times for a setting of 5.00 ms. If your coil set time is too low the sear will not release the striker and it won't fire, but if the setting is too high the battery will drain faster.

Mode lock button is the small button next to the jumper switch for locking semi-auto. Hold it down for a few seconds to default all settings.