PDA

View Full Version : Need info on ACS bolts, please help me. Thanks.


ct_painball_warrior
06-20-2008, 08:43 AM
I am calling on everyone who has an ACS bolt for their Spyder to provide the following info;

#1 Distance from the tip of the bolt (where the bolt touches the paintball) to the air in-take hole (the hole that the air flows thru from the lower chamber to the bolt).

#2 Distance from the pin that mates with the striker to the air in-take hole.

#3 Distance from the pin that mates with the striker to the tip of the bolt.

I need this info to determine if the location of the striker pin and the air intake hole on the ACS bolts are the same as the air in-take hole and cocking pin hole on the MR1 bolts. If they are, I can make an ACS bolt for the MR1 series by removing the striker pin and drill that hole thru to the other side and that will give you an ACS bolt for the MR1's. Of course you would need to remove the top/rear cocking pin that was meant for the other markers and may need to carve out a peace on the bolt for the detent.

Just a thought.

Adam

ct_painball_warrior
06-26-2008, 06:48 AM
Never mind, I just bought one and did the mod.

http://www.spyder.tv/forums/showthread.php?t=17421

Thanks

Adam