PDA

View Full Version : Reloader B2


deano 177
05-17-2008, 06:59 PM
I just got a b2 but I must be slow because I can't figure out how to change the settings. I have tried to do it like the instructions say but I must not be holding my mouth right. Do any of you guys have one of these and know how to change the settings? I just want to make it go as fast as it can(22 bps??).

Griff
05-17-2008, 11:36 PM
If it's just a halo B with the Victory board there is only on and off. With the V35 you get settings. 22 rounds a sec I don't know but it kept up with 18-20 rps.

OSOK
05-17-2008, 11:47 PM
I know with the Empire B you hold it for about 3 seconds when you first turn it on. Then it is like 1-3 presses of the button for different modes.

deano 177
05-18-2008, 11:07 AM
It is a B2. You can adjust the bps, sound sensitivity and force. If you know how:)

bigred76
05-18-2008, 02:24 PM
It's easy enough. Press the button so that it turns on and release it, and when the green light comes on for about a second, press and hold the button again until it turns red. You're now in programming mode. You have the manual link already obviously or a paper manual, so you should be able to figure it out from there. If you still have problems, I'll make a vid with my Reloader B board of how to get into the programming mode. It's the same way as the B2 board, but I can only adjust the speed. I'd advise speed two, as it's good enough for PSP mode and does not popcorn as much as speed three. Then again... my Reloader might be a bit faster than a stock B2....

deano 177
05-19-2008, 02:43 PM
It's easy enough. Press the button so that it turns on and release it, and when the green light comes on for about a second, press and hold the button again until it turns red. You're now in programming mode. You have the manual link already obviously or a paper manual, so you should be able to figure it out from there. If you still have problems, I'll make a vid with my Reloader B board of how to get into the programming mode. It's the same way as the B2 board, but I can only adjust the speed. I'd advise speed two, as it's good enough for PSP mode and does not popcorn as much as speed three. Then again... my Reloader might be a bit faster than a stock B2....
Thanks. I'll give it a try.

deano 177
05-20-2008, 04:16 PM
Ok red, I tried to do it like the instructions say but I'm not getting anywhere. Here are the instructions and what my D.A. has been doing. I really don't need to change the settings but I would like to know what they are and how to do it...

http://i271.photobucket.com/albums/jj145/dean0177/Paintball/EmpireB2directions001-1.jpg


http://i271.photobucket.com/albums/jj145/dean0177/Paintball/th_MOV01976.jpg (http://s271.photobucket.com/albums/jj145/dean0177/Paintball/?action=view&current=MOV01976.flv)