PDA

View Full Version : shorter trigger pull and what barrel?


NoRcO_bOi
05-10-2008, 10:56 AM
Hi there, I have a mr1 and I was looking to make the trigger pull shorter, and I also want a more accurate barrel. I use Monster balls(I know, it's just rec balling) and I was wondering what size barrel I would need to fit these. And what would I have to do to make my trigger pull shorter.

I would also like to have the back of the gun covered up where the stock goes, I believe the hammer is exposed. I would like to have that covered up so dirt doesn't get in there when I am not using the stock.

All help would be highly appreciated, thanks in advanced.

Paul

deano 177
05-10-2008, 11:06 AM
As for plugging up the hole.. try to find a piece of plastic that is the same size as the stock's "mount". If you do just cut it as long as the one on the stock and match the hole pattern. You should be good to go.

Look here (http://www.sundragonpps.com/paintball_spyd_mech_trig_job.html) for the trigger mods..

mr1 sniper
05-10-2008, 12:56 PM
i hear that barrel plugs fit nicely in the back. j&j ceramic

cyberthrasher_706
05-10-2008, 07:35 PM
Whew, found it. I used the mount point from the stock itself, since it was made for it anyway. Seals perfect.
http://www.spyder.tv/forums/showthread.php?p=198757&highlight=bolt+plug#post198757 (http://www.spyder.tv/forums/showthread.php?p=198757&highlight=bolt+plug#post198757)