bartndr
05-07-2008, 03:59 AM
aloha,
On the block is a MR (non-eyes) Trinity feed neck to replace the stock one with the plastic elbow which puts your hopper about 2 1/2 inches higher than it needs to be.
http://www.trinitypaintball.com/v/vspfiles/photos/TR%20393-2T.jpg
Pay-pal prefered, can negotiate on M.O. or checks (though I won't ship until it clears).
asking $30 + shipping (which USPS standard would probably be about $5, it's a small box).
Used 1 day, so it's like new, in original box.
This item will not work on the MR2 w/ eyes or MR3. It doesn't have the length on the 'side' to cover the wires, and it pinches them causing the eyes to malfunction.
But, it does make the hopper sit noticeably lower, and is much sturdier than the stock short piece w/ the plastic elbow attached.
Thanks for looking,
Rob
On the block is a MR (non-eyes) Trinity feed neck to replace the stock one with the plastic elbow which puts your hopper about 2 1/2 inches higher than it needs to be.
http://www.trinitypaintball.com/v/vspfiles/photos/TR%20393-2T.jpg
Pay-pal prefered, can negotiate on M.O. or checks (though I won't ship until it clears).
asking $30 + shipping (which USPS standard would probably be about $5, it's a small box).
Used 1 day, so it's like new, in original box.
This item will not work on the MR2 w/ eyes or MR3. It doesn't have the length on the 'side' to cover the wires, and it pinches them causing the eyes to malfunction.
But, it does make the hopper sit noticeably lower, and is much sturdier than the stock short piece w/ the plastic elbow attached.
Thanks for looking,
Rob