PDA

View Full Version : Help with my remote!


gunz52
04-29-2008, 03:57 PM
Ok, so I got a PMI Pure Energey 3000psi remote from AV. When I connect the CO2 tank to the remote...the pressure relief hole located right below the hose (see picture) at the end where the CO2 tank screws into, it leaks out air like crazy when I turn the screw to begin releasing air into the hose. I just dont get it....

The hole im talking about is the little small one right below where the hose connects...


http://i207.photobucket.com/albums/bb84/gamecox787/IMG_0443.jpg

gunz52
04-29-2008, 04:12 PM
Bumpidy...bumpbump

DFSniper
04-29-2008, 04:24 PM
sounds like its not sealing right. try swapping orings and oiling the threads.

Ace24
04-29-2008, 04:57 PM
Bad o-ring. Problem solved.

Team Ramrod
04-29-2008, 05:31 PM
Like they said above change the oring on your tank. Also, if it persists, try adding another ring into the ASA then screwing your tank on, it will provide a little bit more of a seal.

bigred76
04-29-2008, 06:40 PM
:yeahthat: Also, do not up non-sale threads. Your post will get answered when it gets answered.

gunz52
05-02-2008, 12:53 PM
Ok, I will keep that in mind. But, when I connected the tank directly to the MR1, it did fine. (as the MR1 also has a pressure relief hole also)