PDA

View Full Version : Need some help with the bolt pin and ball bearing!


boughtasonix
03-14-2008, 03:03 PM
Ok, so i disassembled my sonix all the way. I didn't know there was a bearing in there, and i dont know how to put it back in. As I said, I have nothing in place. Thanks for helping, if you can post.

davmitchell77
04-09-2008, 08:51 AM
there is no bearing in there.
how "complete" is the dissassembly? did you remove the valve?
In order from valve to rear of marker (lower tube) you should have: striker with oring, striker spring, rubber buffer (big fat rubber washer), spring guide (looks like a nail), spring guide shim (sometimes there, sometimes not- looks like metal washer with no hole), and rear plug. the shim, spring guide, and spring feed into the hole in the rear plug.
if you took the valve out, put it (with orings) in with the lip towards the front of the marker. then the valve guide (metal star) goes on the cup seal (plastic pushpin looking piece of valve), held in place by the valve spring, and stick the whole shpeel into the front of the lower tube. make sure the valve stem drops into the valve. put in the front plug.